Rockwell Rk5102k Sonicrafter The powerful tool ever used.
I have review as below.. no complaints at all.
1) Diving cut drywall. Working with a large semicircular blade general. Cut a straight line, quite clean, and it is not hard to eyeball an even layer and cut well. Do not cut like a hot knife through butter, it takes patience. Cut smoothly.
2) Immerse the wood. I need to see a piece of a piece of fence is in an awkward area near the wall of my house. I thin with this tool and the blade straight in black at an angle of 45 degrees and cut. Again, cut well, but not as a hot knife through butter, and I do not try it with a lot of pressure disturbances.
3) grind the old grout tile bathroom. The walls have settlement and corner grout has cracked and separated. I tried the semi-chisel and hammer mill. I was a bit of ground, but this is slow. Moreover, the thickness of the grout so that the tool was ground by a thin line. At the end I took a hammer and chisel, the majority of the work.
I do not know the road scrapper or crushing pills for everything yet. I feel like this tool is mainly used to strange situations, or change something that is already as dry wall, design, fences, etc.
It is necessary that the screw torque to the road in very closely. Comes with a spare screw should strip him. I feel like the mask would have been a little deeper, the leaves or clutch to manage the tool, and then the screw is not very complicated, and the leaves fall. If you do not tighten the screw enough to slip the knife with a bit of lateral pressure.
