rockwell tools jawhorse is a well made, robust working tool that deserves all the positive comments. Setup and operation are simple and intuitive. Basically, a ratchet jaw (as in the old car-jack style) is used for clamping action. The jaws can be reversed to their films, so you can clip large objects, or almost completely, and the sides are pine surface with rubber pads are hard and large and stable enough to clamp vertical section. The pawl is supported by a pedal. When fully pressed clamp, slide a switch on the front to lock the pawl in place. Easily to the device that catches be folded for compact storage. For some reason, a role for the trailer when it collapsed, why rockwell tools jawhorse as useful as his team, although they could be helpful for people with restricted movement a kind of question. The third leg is easily located for use of the device, simply and clearly states that drawing from his seat as necessary when the closing device (also serves as a trailer hitch for the trailer until the closure of its unit paper). It has a screw then coated with plastic, once again, that is near, if it lasts long enough. The important thing is not that closely, but is advisable. Also accompanying the purchase, the rockwell tools jawhorse RK9109 pine plywood plant equipment, and for my purposes, it is well worth it. It is simply a replacement for the pine, with Jawhorse, but in contrast, offers a much greater openness. Is too long to fall apart, so that you do both cheeks. A pine or sliding off the device is very simple, so it is not a problem with use. To fully support something as big as a 4 times 8 sheet of plywood, it is necessary to make objects or other means of support to the slope (not surprisingly). The accessory comes with 2 clips for the manufacture of articles of 2 times 2 or 2 times 4 stock (think in terms of support that an 8 ‘piece sets with legs at each end … that supports cross-piece is in the jaws of the clamp in plywood of the slope).
order the rockwell saw horse